Sti UB-1PN Manual do Utilizador descarregar pdf (Página 3)

- 3 -

1. Choose button message and color. If same as existing, proceed to

2. If choosing a new message, remove button. On the back side of the plate,

squeeze tabs and push actuator assembly into plate just enough to grasp the

button and remove.

3. From the front of the plate, push actuator back into original position.

4. Choose button message. Blank plate is available for your custom message.

a. Insert button message, align 4 notches on actuator.

b. Select color lens. Align top and bottom notches with tabs on

actuator and push until it snaps together.

TO CHANGE BUTTON COLOR AND ROUND MESSAGE

HANGE TO

MESSAGE

1. Remove LED circuit board.

2. Remove current message by pushing in and

down on tabs 1 and 2 with a small

screwdriver. If necessary, also push in and

down on tabs 3 and 4. Once message is loose,

remove from the front of the plate.

Select new message and snap into place.

Blank plates are included to create your own

custom message.

DIFFUSER

BUT

SCREWDRIVER

BUT

BUTTON ACTIVATED

UB-1L LED PCB

NYLON WASHER

SCREW

AND

INTO

1 2 3 4 5 6 7 8

Sem comentários

Sti UB-1PN Manual do Utilizador Página 3